SECTION 9.2
CUB CRAFTERS
SUPPLEMENT- SINGLE PLACE CONVERSION
CC11-100
REPORT SC10000AFM
Issued: 04/15/09
Page Number: 9-2-10
Date of Revision: 10/31/11
4. The seat cross bar can either be securely stowed
in the aft baggage compartment or reinstalled in
the fuselage cross bar slots. If the cross bar is
reinstalled, the nylon straps must be reinstalled on
the cross bar and attached to the floorboard in
order to securely hold the seat cross bar in place.
5. Tuck the seat cushion and, if cross bar not
reinstalled, nylon cross bar nylon straps in the
sling seat holder.
6. If the seat is completely removed from the aircraft,
loosen the two straps at the top of the seat and
remove the seat, and rear seat cross tube. If
removed, note that the 6.15 lbs includes the entire
seat and cross bar.
7. Adjust weight and balance information accordingly
if the seat is removed.
8. Reinstallation involves dropping the seat down out
of the storage area (or installing the top straps if
the seat was removed) and inserting the rear seat
cross tube and hold down straps, then fastening
the hold down straps back to the floor.
9.2.3.6 REAR SEAT HARNESSES / RESTRAINTS
1. If the aircraft will be operated without a rear seat,
stow the lap and shoulder harnesses such that it
cannot interfere with safe operation of the aircraft.
