SECTION 9.2
CUB CRAFTERS
SUPPLEMENT- SINGLE PLACE CONVERSION
CC11-100
REPORT SC10000AFM
Issued: 04/15/09
Page Number: 9-2-8
Date of Revision: 10/31/11
4. Move the front control stick through the full range
of motion (including trim) and ensure there is no
contact between the rear stick stub and the stick
cover.
5. Adjust weight and balance information
accordingly.
6. For reinstallation, remove the stick cover, install
the fasteners back into the floorboard. Install the
rear stick and torque the fastener to 43-48 in-lbs.
Ensure full range of motion (including trim) is met
without the rear stick contracting anything. Adjust
weight and balance information accordingly.
9.2.3.5 REAR SEAT REMOVAL OR STOWAGE
1. Disconnect the two cinched nylon straps holding
the seat cross bar to the floor by unscrewing and
pushing in on the screw. This will allow the tab to
rotate and slide the pin out of the seat base
connector.
2. Lift the rear seat cross bar up and out of the
retaining slots.
SCREW
