CTM 360a series, Maintenance And Service Manual

Page: 71 / 176

GENENRAL MAINTENANCE
8-2
MAINTENANCE
NOTE: Since all three types of Applicator are covered in this Section, some items
discussed will not pertain to your application.
DAILY MAINTENANCE
1. Examine the Peel Edge, Blow Box Grid, Label Pad and Rollers for excessive adhesive build-up.
If necessary, clean these surfaces with alcohol or similar solvent.
2.
Examine Air Filter for water or oil collection. Drain if necessary.
3.
Examine for loose screws, rollers, etc.
WEEKLY MAINTENANCE
1.
Clean rollers, Blow Box Grid, Label Pad, and Peel Edge of adhesive build-up and dust.
2.
Examine air lines and connections to make sure there are no leaks.
3.
Examine for loose screws, rollers, etc.
4.
Examine UHMW Tape on Peel Edge. Replace if needed.
MONTHLY MAINTENANCE
1.
Examine Dancer Arm Tension and Unwind Brake O-Ring.
2.
Examine Drive and Rewind Belts for wear and to make sure they are properly adjusted.
3.
Examine Rollers for free rotation and play.
4.
Examine Rewind Slip Clutch Disk for wear.
5.
Replace the Air Inlet Filter.
6.
Examine UHMW Tape on Peel Edge. Replace if needed.