CTM 360a series, Maintenance And Service Manual

Page: 17 / 176

360a DISPLAY
3-5
MAIN MENU
The Main Menu is divided into three sections.
The upper right corner of the Display is a Status
Window. The purpose of this box is to inform
the operator of the status of the Applicator. The
display shown to the left appears immediately
after going offline. If the Applicator is online
with no alarms, the Status Window will have a
green background with the label rate displayed.
If a Warning Alarm occurs, the background
changes color and a message will appear
indicating the nature of the alarm. Specific
Warning Alarms were discussed previously.
The left side of the screen will change based on Applicator Type. There will always be Jog and Alarm
Reset keys and access to Label Placement.
The lower right corner has buttons to place the Applicator on and offline and keys to take you to the
Formats and Setup Menus. Placing the Applicator online applies power to the Drive Motor and arms the
Applicator for labeling. The Format Key gives access to the operator to load a saved Format. The operator
cannot change or erase Formats from here. The Setup Key takes the operator to a password-protected area
to make changes to the operation of the Applicator.
The Display is equipped with a backlight saver function that automatically turns off the backlight after 60
minutes of inactivity. Pressing any part of the Display will turn the backlight on again. Also, the
Applicator will initiate a backlight wake-up in response to any Critical Alarm condition. The later feature
insures that the operator has a visual indication of a Critical Alarm condition in systems without a Light-
Stack Assembly.
SETUP MENU
Because the Setup Menus are password-protected,
pressing the Setup Key at the Main Menu will
cause a password screen to appear. By entering the
correct password will cause the Setup Menu to
come up. From here the operator can go to the
different setup sections. The operator can also
bring the Applicator online while he changes the
setups. Once the Applicator is setup and the
operator exits the Setup Menu, the Applicator will
save the new settings. If power is cycled to the
Applicator before the Display is returned to the
Main Menu, the new settings will not be saved.
Note: You must be offline to enter the
Configuration Menu.