CTM 360a series, Maintenance And Service Manual

Page: 101 / 176

CHANGEOVER INSTRUCTIONS
12-8
REWIND REMOVAL
1) Remove the belt connecting the rewind clutch to the motor.
2) Remove the rewind mandrel from its drive shaft.
3) Remove the six #10 screws that hold the rewind mounting plate to the housing.
REWIND INSTALLATION
1) Attach the rewind mounting plate to the housing using the six #10 screws.
2) Install the rewind mandrel on the mandrel drive shaft.
3) Install the belt connecting the rewind clutch to the motor.
REWIND CHANGEOVER
1) Remove the bearing block that is mounted to the rewind transition plate.
2) Remove the pulley from the shaft making sure to note its position relative to the end of the shaft.
3) Remove the snap ring from the pulley side of the assembly and push the rewind shaft out through the
mandrel side. Note: The shaft diameter on the mandrel side is larger than it is on the pulley side.
Do not attempt to force the shaft out through the pulley side!
4) Re-install the shaft in the opposite side of the bearing block and replace the snap ring. Note: The shaft
can only rotate in one direction due to a directional bearing in the bearing block.
5) Install the pulley on the shaft in the same position as it was previously.
6) Re-mount bearing block to the opposite side of the transition plate.