CTM 360a series, Maintenance And Service Manual

Page: 43 / 176

360a DISPLAY
3-31
SPECIAL OPTIONS SECTION (cont’d)
Missing Label Mode –
This Option only
appears if the Applicator Type is set to Air
Blow or Tamp, Normal or Inverted, and the
Missing Label Option is turned on in the
Applicator Options Menu (pg. 3-24). Turning
the Missing Label Option in the Applicator
Options Menu only turns Mode 1 on. The
Mode that is currently selected will be
displayed. The operator can press the “Up” or
“Down” Keys to change the Mode. The
Missing Label Option cannot be turned off in
the Special Options Menu; to turn the Option
off the operator must do so in the Applicator
Options Menu. There is a Help Key that gives a brief explanation of each Mode.
Auto Online Option – With this Option Enabled, after the Applicator has finished its power-up sequence,
the Applicator will automatically be placed
Online. If the Applicator Type is set to
anything other than a Merge, the operator will
be responsible for “jogging” the first label. If
the Applicator is not manually cycled, the first
product through will not be labeled as there was
not a label on the Pad/Grid.
Product Detect Debounce Time –
With this
Option Enabled, the signal from the Product
Detect Sensor must be active for longer than the
time set for the Debounce Time. Once the
Applicator receives the Product Detect Input,
the Debounce Time is started. When the
Debounce Time is finished, the Applicator will
check the status of the Product Detect Input
again. If the Input is still active, the Applicator
will continue the labeling sequence. If the
Input is not active, then that product detect will
be ignored and the Applicator will begin to look
for the next Product Detect Input.