CTM 360a series, Maintenance And Service Manual

Page: 20 / 176

360a DISPLAY
3-8
LABEL SETUP (cont’d)
Label Formats
This section allows the operator to save and load configuration setups for up to (48) different products and
labels. This is useful if a customer is running several different products or labels over and over.
Note: The Label Format Key at the Main Menu only allows the operator to only load Formats.
A format saves the following parameters:
Label Placement Encoder Option
Label Length Pulse Length
Label Stop Compensation
Detector Lockout Air Blast Time
Web Speed Ext. Air Assist
Slew Speed Tamp Extend
Max Speed Tamp Retract
Accel Pre-Dispense
Decel
Options and Variables
Consult factory for a complete list of
Parameters saved.
This screen will show the last Format
loaded. If no Formats had been loaded,
the value in the box would be “0000”.
Saving a Format
If the current setup in the Applicator is
performing correctly and you want to save it,
press “Label Formats” in the Label Setup
Menu. When a “Save” key is pressed, the
Applicator will check to see if a Format
already exists in the location selected. If it
does, the operator will be prompted whether
or not to overwrite its contents with the new
information. If the name is “0000”, the
operator will be asked to enter up to four
digits for the Format Name. Pressing the
green Save Format key, saves the Format to
the name shown in the Format Name box
provided the name is not already used for another Format. If it is, the system prompts the user to select a
different name. Pressing the red Exit Key on the screen allows the operator to exit without saving the
Format.
Main Menu Format Screen
Main Format Screen