CTC Parker Automation PowerStation P1, User Manual, Page: 51 / 86

Installing the Unit
P1 PowerStation User Guide
43
Installing the Unit
Once you have prepared the mounting location for the PowerStation and
the AC power supply (if purchased), you can begin installing the unit.
Mounting the PowerStation
The PowerStation is designed to be mounted using four screws. These
screws are secured to the unit with metal clips. For your convenience, CTC
Parker includes all necessary hardware for mounting the unit. Follow these
steps to mount the unit:
1. Prepare the power source for the unit by sliding the positive and neg-
ative wires into the appropriate slots on the power connector.
2. Connect the ground cable from the power connector to an earth
ground.
3. Slide the gasket around the outside of the PowerStation case, position-
ing it flush against the back of the faceplate.
4. Gently insert the PowerStation into the cutout.
5. Prepare the mounting hardware that was supplied with the unit. Begin
by threading each of the supplied metal clips with a screw. Snap each
of the clips onto the outside of the unit.
6. Attach the power connector that you prepared in steps 1 and 2 to the
back of the unit.
7. Tighten each of the mounting screws.
Important The unit must fit flush against the enclosure. Tighten the nuts in a
crosswise sequence to ensure a good seal and prevent damage to the
unit.
Mounting the AC Power Supply
The AC power supply is designed to be mounted using two metal brackets
found in the AC Power Supply Mounting Kit. These brackets are secured
to the mounting surface using four screws. Follow these steps to mount the
power supply:
1. Prepare the power source for the unit by sliding the positive and neg-
ative wires into the appropriate slots on the power connector.
StockCheck.com