CTC Parker Automation PowerStation P1, User Manual, Page: 34 / 86

Powering Up the PowerStation
26
P1 PowerStation User Guide
Powering Up the PowerStation
Once you have unpacked the PowerStation, you can power it up for the
first time. Complete the following steps to power up the PowerStation:
1. Verify that the power switch is in the OFF position.
2. Connect the PowerStation to a 18-30VDC power source.
Note If you are using an AC power supply, you must first connect the
power supply to the power connector on the back of the PowerSta-
tion. Connect the power supply to a 90 to 260VAC, 50-440HZ
power source.
3. Move the power switch to the ON position.
Using the Shell Utility
Prior to using the PowerStation you should understand the features avail-
able with the PowerStation Shell Utility. The PowerStation Shell Utility
(referred to throughout this document as “the Shell”) is a program that runs
on the PowerStation and is used to configure the unit and enable various
features.
The Shell MAIN MENU is made up of a display area and two rows of
selection buttons which are described in the Menu Definitions section. The
display area contains information about the project currently loaded on the
PowerStation. If no project exists, these settings will be set to NONE.
StockCheck.com