21
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water Cooler
Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Note: Begin with the unit unplugged, the water drained, and the back panel removed.
CAUTION: WATER IN HOT TANK IS VERY HOT AND CAN CAUSE SEVERE BURNS. ALLOW SUFFICIENT TIME
FOR THE HOT WATER TO COOL BEFORE DRAINING (1
-
2 HOURS).
Tip: Use a small flathead screwdriver to pry wire connectors off.
1.
Use the access key to open the top cover. Release and open the latch (Fig. 1). Turn the two blue locking tabs (Fig. 2 & 3). Pull
the SmartFlo
™
up approximately 4
-
6 inches (Fig. 4)
.
2.
Turn the red locking clips and lift away the coffee pod holder (Fig. 5). Undo the two locking latches and lift off the pod hold-
er base (Fig. 6). Remove the three screws holding the coffee module base. Lift up and gently move out of the way (Fig. 7 &
8).
3.
Remove the screw that secures the steam valve (Fig. 9). Remove the steam valve to access the three hot tank screws. (Fig. 10
& 11). Do not remove these screws, yet.
Fig. 2
Fig. 1
Fig. 4
Fig. 3
Fig. 6
Fig. 5
Fig. 8
Fig. 7
Fig. 9
Fig. 10
Fig. 11
Hot Tank Replacement