12
A blinking blue light above the cold water lever and a blinking
“
Replace Bottle
”
on the brew selection panel will alert you when
your water bottle is getting low. Water may be dispensed normally until empty (no water flows from the water outlets when lev-
ers are depressed).
Note: A flashing blue light above the cold water lever will alert you to when the SmartFlo Water Cartridge should be replaced.
The system has been pre
-
set to provide indication after a period of 12 months of use. User may operate the cooler as normal until
the bottle has been emptied. Note: To reset the life timer system, the SmartFlo is required to be removed from the dispenser for a
minimum of 15 seconds while the unit is connected to the mains power supply.
1.
Open Dispenser door (Fig. 11). Slide door upward to access bottle area.
2.
Slide empty bottle out of cabinet (Fig. 12).
3.
Place a fresh bottle outside of the cabinet.
4.
Clean the outside of new bottle with a cloth (Fig. 13). Remove the security label/seal from the bottle cap (if
applicable).
5.
Remove bottle adaptor from the empty bottle (Fig.14) and remove the cap from the Hose Assembly (Fig.15).
Note: to maintain sanitization of the system, refrain from touching the section of the bottle adapter tube that
is inserted into the bottle.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Changing the Water Bottle