CRS F3, User Manual

Page: 69 / 128

Chapter 5: Installation 55
99-05-31
•
A 10 mm hex key
Preparing a mounting platform
1. Referring to the drawing below, drill and tap four holes for M12 x 1.75
screws.
2. If you require precise mounting, drill and ream two holes for M6 dowel
pins according to the drawing.
3. If you are using a mounting plate, prepare it following the above steps.
Firmly fasten the plate to your bench, bracket or similar supporting
structure. Pin the plate if necessary.
Mounting the arm on the platform
To mount the arm on the platform:
1. Install the dowel pins (if used).
Note: The dowel pins must be in the holes of the platform before lifting
the arm onto the platform.
2. With a crane or at least two people, lift the arm onto the mounting
platform.
3. Secure the arm to the platform with 4 x M12 x 1.75 x 50 mm long,
stainless steel 18-8 (A2), hex socket cap screw. A mounting kit consisting
of these fasteners and dowel pins is available from CRS.