Creo Dolev 4press V, User Manual

Page: 18 / 121

2 Safety Precautions
Installation Safety Precautions
Setting the Line Voltage Selector
At the factory, the imagesetter is set to a line voltage of 220 volts. If this
setting does not match your local voltage, you need to change the position
of the voltage selector
.
The present voltage selector setting appears in a small window on the
electronic power drawer assembly located on the rear side of the
imagesetter (adjacent to the master circuit breaker).
To set the line voltage:
1.
Measure the line voltage at the wall outlet. The measured line voltage
should suit the nominal line voltage in your country.
2. Use the following table to determine the required setting:
Note: Read this chapter carefully before installing, operating, or maintaining the
Dolev 4press V/V
2
imagesetter
.
CAUTION: Installation must be done by authorized service personnel only.
To avoid the risk of fire, no connections to the supply are to be made before
setting the line voltage selector.
Note: For all voltage settings, leave the two (2) fuses supplied by the factory
(T 6.3A 250V).
Measured Voltage Voltage Selector Setting
90 V to 109 V 100 V
110 V to 127 V 120 V
180 V to 229 V 220 V
a
a. Factory setting
230 V to 254 V 240 V