Creo Dolev 4press V, User Manual

Page: 38 / 121

22 Chapter 1 – Introduction to the Imagesetter
If, after switching on, the beep is not heard, proceed as follows:
1.
Press on the l e ft side of the On/Off switch to turn off the imagesetter.
2.
Press on the lower part of the master power breaker to power off the
imagesetter.
3.
Check that the power cord is plugged into the wall outlet (or electrical
strip) on one end, and to the imagesetter on the other.
4.
Check that a current reaches the outlet (that is, there has not been a
short circuit).
5.
Press on the upper part of the master power breaker to power on the
imagesetter.
6.
Press on the right side of the On/Off switch to turn on the imagesetter.