MODEL MQHAR
19856-100 Rev D (05-14)
© Copyright 2013, Creative Playthings
Page 21
AssEMbLy InsTRuCTIOns
sTEP 30 — swing Mounts:
Fasten the two Swing Mounts (M) to the Left Wall Support
and Lower Wall Support using two 1/4 x 3-1/2" Hex Bolts
each. Be sure to orient the Swing Mounts so the holes on the
sides are closer to the top.
sTEP 31 – Lower Wall slats & Entrance slats:
Fasten three Short Wall Slats (AC) to the Left Wall Support and
Lower Wall Support using four #6 x 1-1/8" Screws each. Evenly
space the Slats between the front left post and the left Midpost.
The gap between the Slats will be approximately 1-5/8"
Fasten six Short Wall Slats (AC) to the Left Wall Support and
Lower Wall Support using four #6 x 1-1/8" Screws each. Evenly
space the Slats between the back left post and the left Midpost.
The gap between the Slats will be approximately 1-7/8".
Fasten the Entrance Slats (AB) to the Right Wall Support and
Rock Wall Mount using #6 x 1-1/8" Screws. Leave a gap of
19" between the Entrance Slats.
3-1/2" Hex Bolts
M
AB
BG
BE
sTEP 29 — Lower and short Wall supports:
Fasten the top back hole of the Lower Wall Support (BG) to
the post shown using one 1/4 x 3-1/2" Hex Bolt Assembly.
Fasten the Lower Wall Support to the left Midpost and front
left post using 1/4 x 2" Hex Bolt Assemblies through the up-
per holes. Secure the three lower holes in the Lower Wall
Support using 1/4 x 2" Lag Screws and Flat Washers.
Fasten the Short Wall Support (E) to the right Midpost and
front right Post using 1/4 x 2" Hex Bolt Assemblies through
the upper holes. Secure the lower holes using 1/4 x 2" Lag
Screws and Flat Washers.
19"
