© Copyright 2013, Creative Playthings
MODEL MQHAR
19856-100 Rev D (05-14)
Page 34
AssEMbLy InsTRuCTIOns
sTEP 64 — nameplate:
It is important to fasten the name plate to the Swing Beam.
Federal safety regulations require that the name of the man-
ufacturer be permanently fastened to the gym, for identifica-
tion in case of warranty claim.
Center the name plate near the middle of the Beam. use the
included #6 x 1/2" pan head screws to attach the Nameplate
to the Beam. Make sure that the screws are slightly loose.
This will keep the Nameplate from bending due to tempera-
ture and moisture changes in the wood.
sTEP 65 — Ground stakes:
Hammer two Ground Stakes (CQ) next to the Front Left Post
and Back Right Post as shown. The top of the Ground Stake
should be minimum of 1/8" below the top of the Sandbox
components. Secure each stake with two #8 x 2-1/2" Screws
through the pre-drilled holes.
Hammer Ground Stakes next to the Access Ladder and Car-
go upright as shown. Secure each stake with two #8 x 2-1/2"
Screws through the pre-drilled holes. Secure the Beam Legs
in the same manner
Note: Do NOT use concrete to set Ground Stakes. Pound
a metal spike or rod into the
ground to start a hole in
hard or rocky ground.
