© Copyright 2013, Creative Playthings
MODEL MQHAR
19856-100 Rev D (05-14)
Page 24
AssEMbLy InsTRuCTIOns
sTEP 37 – Install Tent frame:
With the help of another adult and the use of a step ladder, set
the tent frame assembly in place. Align the holes in the Long
Tent Supports with the holes in the corner uprights. Align the
holes in the Tent uprights with the holes in the End Wall Sup-
ports.
Fasten the Tent uprights to the End Supports using 1/4 x 1"
Hex Bolt Assemblies.
Fasten the Long Tent Supports to the corner uprights using 1/4
x 4" Hex Bolt Assemblies.
sTEP 38 – Rock stringer:
Fasten the top of the Rock Stringer (Bu) to the Platform
Back using one 1/4 x 2" Hex Bolt Assembly.
use two #8 x 2-1/2" Screws to fasten the Bottom Block to
the Rock Stringer flush with back and bottom edges of the
Rock Stringer.
Rest the Bottom Block against the adjacent Sandbox End.
use a level to make sure the Rock Stringer is
plumb. Mark the center of the thickness of
the Bottom Block on the Sandbox End.
Drill two 3/16" diameter holes through
the Sandbox End even with the mark,
one 1" from the top and one 1" from
the bottom of the Sandbox End. Fasten
using one #8 x 1-5/8" Screw through
each hole.
sTEP 39 — Rock & spacer boards:
Fasten one Rock Board (AF) to the Rock upright and adja-
cent post just below the Platform Back using four #8 x 1-1/2"
Screws, in the position shown. Leave a gap of approximate-
ly 1/4" between the top of the Rock Board and the bottom of
the Platform Back.
Fasten the bottom Rock Board 1/4" above the Lookout Base
Side in the orientation shown using four #8 x 1-1/2" Screws.
Make sure the board is level.
Evenly space Rock Boards and Spacer Boards (AA) in the
opening between the existing Rock Boards. Alternate the
orientation of the Rock Boards as shown. The gap between
boards will be approximately 1/4".
1/4 x 1" Hex Bolts
1/4 x 4" Hex
Bolts
1/4 x 2" Hex
Bolt
#8 x 1-5/8" Screws
1/4" Gap
1/4" Gap
1-5/8" Screws
2-1/2" Screws
Bu
AQ
AF
AA
