© Copyright 2013, Creative Playthings
MODEL MQHAR
19856-100 Rev D (05-14)
Page 12
AssEMbLy InsTRuCTIOns
sTEP 4 – base sides:
Insert a 1/4"
short
Weld Nut into the top hole at one cor-
ner of a Lookout Base Side (CG). Pass one 1/4 x 4" Hex
Bolt though a Lock Washer, a Flat Washer, the top hole of
a Sandbox Side (BC), and the middle left post assembly to
secure the Lookout Base Side.
Secure the Sandbox Side to the left post using one 1/4 x 2"
Lag Screw and Flat Washer from the outside. Secure the
Lookout Base Side to the left post using one 1/4 x 2" Lag
Screw and Flat Washer from the inside.
Fasten The Sandbox Side to the front left post assembly us-
ing a 1/4 x 3" Hex Bolt Assembly through the top hole and
a 1/4 x 2" Lag Screw and Flat Washer through the bottom.
Repeat the process with the other Sandbox Side, Lookout
Base Side and the right post assemblies.
sTEP 5 – base Ends:
Fasten one Sandbox End (BB) to the outside of the front left
and right post assemblies as shown at left. use 1/4 x 4" Hex
Bolt Assemblies in the top holes and 1/4" x 2" Lag Screws
with 1/4" Flat Washers in the bottom holes.
Fasten the other Sandbox End (BB) to the inside of the
middle left and right post assemblies in the same way.
sTEP 6 – Platform Ends:
Fasten the Platform Front (BD) to the front left and right
post assemblies as shown at right. use 1/4 x 4" Hex Bolt
Assemblies in the top holes and 1/4" x 2" Lag Screws with
1/4" Flat Washers in the bottom holes.
Fasten the Platform Back (BW) to the middle post assemblies
in the same way.
3" Hex Bolt Assembly
2" Lag Screw in
Bottom Holes
2" Lag Screw in
bottom holes
2" Lag Screw in
Bottom Holes
CG
BC
BB
BW
BD
4" Hex Bolt
Assembly w/
Short Weld Nut
Short Weld Nut
4" Hex Bolt
Assembly in top
holes
4" Hex Bolt
Assembly in top
holes
