© Copyright 2013, Creative Playthings
MODEL MQHAR
19856-100 Rev D (05-14)
Page 16
AssEMbLy InsTRuCTIOns
sTEP 16 – Lunch base and Platform End:
Fasten the Lunch Base (BN) near the bottom of the look-
out posts using two 1/4 x 4" Hex Bolt Assemblies in the top
Holes and two 1/4 x 2" Lag Screws and Flat Washers in the
bottom holes.
Fasten the Platform End (CJ) in the same way. Be sure the
part is aligned properly and fastened in the correct position.
sTEP 17 – Inner Deck support:
Hold the Inner Deck Support (AH) in place as shown at right.
The holes in the ends of the support should align with the
counter-bored holes in the Lookout Platform Sides and the
off-center hole near the middle should align with a hole in the
Center Ladder Rail.
Fasten the Inner Deck Support to the Lookout Platform
Sides using 1/4 x 4" Lag Screws and Flat Washers. Fasten
the Inner Deck Support to the Center Ladder Rail using one
1/4 x 3-1/2" Hex Bolt Assembly.
sTEP 18 – upper stringer:
Fasten the upper Stringer (P) to the Inner Deck Support us-
ing one 1/4 x 4" Lag Screw and Flat Washer. Align the Sup-
per Stringer with the widest face horizontal and the top of the
Stringer even with the top of the Inner Deck Support.
Fasten the other end of the upper Stringer to the Platform
End using one 1/4 x 3" Lag Screw and Flat Washer. The top
face of the upper Stringer will be well below the top of the
Platform End.
BN
AH
P
CJ
1/4 x 2" Lag Screw
1/4 x 4"
Lag Screw
1/4 x 4"
Lag Screw
1/4 x 3"
Lag Screw
1/4 x 2"
Lag Screw
1/4 x 4" Hex Bolt
1/4 x 3-1/2"
Hex Bolt
1/4 x 4" Hex Bolt
