Processor and Heatsink Replacement
Prerequisites
● The 2600 motherboard is removed from the chassis and is placed on a stable ESD-safe work surface.
●
Part Numbers:
○ Refer to
on page 5 for a list of all processor models, common supplies, and
tools.
●
Tools:
○ Phillips screwdriver, #2
○ Vacuum pen
○ Plastic putty knife
●
Supplies:
○ Isopropyl alcohol, 90% or higher concentration
○ Clean, lint-free cloth
○ Thermal paste/grease
About this task
This procedure describes how to replace a passive heatsink and processor from an Intel
®
S2600 motherboard.
Motherboards are not shipped with processors installed. Processors, heatsinks, and memory DIMMs must be
removed from the defective motherboard and installed on the replacement motherboard.
Remove Heatsink
The heatsink is attached to the processor socket with captive fasteners. Use a #2 Phillips screwdriver to
loosen four screws located on the heatsink corners in a diagonal pattern.
1.
Start with one screw (A) and loosen it by giving it two rotations. Refer to the following figure.
2.
Proceed to loosen the remaining screws (B, C, and D) by giving each two rotations. Repeat this process by
loosening each screw two rotations, each time, until all screws are loosened.
3.
Lift the heatsink straight up.
Motherboard, Processor and DIMM Replacement
HR90-2009
34
CS400-AC Hardware Replacement Procedures