![background image](http://html1.mh-extra.com/html/crary/air-reel-1010/air-reel-1010_owners-manual_2679350018.webp)
PN 12069 R072208
14
ASSEMBLY
4.4 GeaRboX/Fan mounT - 1993/1994 SeRieS (15-22.5 FT. headeRS)
Position the mount plate support on the back of the header
1.
as shown in Figure 6 and clamp in place.
Mark and drill four 27/64” (.4218”) holes and tap to 1/2-13
2.
NC for the mount plate support.
Attach the mount plate support to the header with four
3.
1/2” x 1-1/4” serrated flange bolts and washers. Torque to
75 ft-lbs.
Attach gearbox mount plates to the mount plate support
4.
with 1/2” x 1-1/4” serrated flange bolts (Figure 7). Do not
tighten at this time.
Lift the gearbox/fan into position using a floor jack or over
-
5.
head hoist and attach to the mount plates with four 1/2” bolts
and washers. Do not tighten at this time.
Check the gearbox and, if necessary, fill the gearbox with
6.
lube before use.
Use Mobilube SHC 75W-90 synthetic gear lube or
equivalent with the following specifications:
API Service GL-5/MT.1
MIL-L-2105D
MACK GO-J PLUS
SAE J2360
Capacity: 40 oz. (1.2 L)
Keep gearbox/fan suspended with hoist or jack to install the
7.
right hand drive kit.
Figure 6, Gearbox/fan mount dimensions (1993/1994 series headers 15’-22.5’)
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRninG