![background image](http://html1.mh-extra.com/html/crary/air-reel-1010/air-reel-1010_owners-manual_2679350040.webp)
PN 12069 R072208
36
ASSEMBLY
Avoid crushing injury or death from fall of raised reel.
Before working on or under a raised reel, place all controls
in neutral or off, stop combine engine, set parking brake,
remove ignition key, wait for all moving parts to stop and set
cylinder stops on both sides of reel before servicing, adjusting,
repairing, or unplugging.
WaRninG
4.18.2 RiGhT hand
Insert the short reel support pad into the RH reel support
1.
assembly and slide onto the RH reel arm (Figure 35).
Bolt an adjustment tube to the RH reel support assembly
2.
with two 1/2” x 3” bolts and nuts.
Fasten the base end of the OEM hydraulic cylinder to the
3.
OEM support assembly clevis with clevis pin and cotter
pin.
Fasten the rod end of the hydraulic cylinder to the cylinder
4.
tube weldment using clevis pin and cotter pin.
Fasten the cylinder tube weldment to the adjustment tube
5.
weldment with OEM hardware.
Install a reel support yoke to existing holes in the RH reel arm
6.
with 1/4” x 2-3/4” bolts and serrated flange nuts.
4.18 Reel SuPPoRT (hYdRaulic FoRe & aFT)
4.18.1 leFT hand
Insert the long reel support pad into the OEM LH reel support
1.
assembly and slide onto the LH reel arm (Figure 34).
Fasten the rod end of the OEM hydraulic cylinder to the reel
2.
support clevis with clevis pin and cotter pin.
Install a spacer on each side of the front bottom hole on
3.
the LH reel arm with a 1/2” x 4” bolt and locknut. Torque to
75 ft-lbs.
Figure 34, Hydraulic fore and aft reel support (left hand)