PN 12069 R072208
57
SERVICE & MAINTENANCE
6.10 auGeR dRive chain lubRicaTion
This section applies to 1993 and later series headers
(15-22.5 ft.). Every 50 hours the auger drive chain should be
lubricated. When lubricating the chain, follow this procedure:
Remove the chain drive shield weldment (Figure 59).
1.
Lubricate the roller chain every 50 hours of operation with a
2.
light motor oil to extend wear life.
Use a spray chain lubricant or engine oil (see chart).
3.
Remove the chains from the machine for cleaning and lubri-
4.
cation at the end of every season. Soak roller chains in diesel
fuel to clean. Dry and then oil chain thoroughly.
* Stamped on chain link side plate.
chain
TYPe*
ambienT TemPeRaTuRe RanGe
14° F - 32° F
32° F - 104° F
104° F - 122° F
RS-50 LESS
SAE 10
SAE 20
SAE 30
RS-60 / RS-80
SAE 20
SAE 30
SAE 40
RS-100
SAE 20
SAE 30
SAE 40
RS-120 / MORE
SAE 30
SAE 40
SAE 40
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRninG
Figure 59, Auger chain lube