Crane Merchandising Systems Merchant 180, Operator'S Manual

Page: 36 / 170

Initial Setup Merchant™ Operators’ Guide
January 2008 28 1810006
PREPARING THE MERCHANDISER FOR VENDING "TOP SHELF"
National Vendors recommends that this product be vended from a candy tray.
Move the tray so the package can be loaded standing on its left or right edge.
(See “Hold the coupler bearing in place and push the spiral coupler through the bearing until the cou-
pler clicks into position. Be sure the coupler is in the proper orientation as shown.” on page 21).
The following steps must be completed for three adjacent positions on the tray:
NOTE
The left-most position in the group of three
must be an even numbered position.
NOTE
If the motor harness you disconnected in step 5 does not reach, use the
motor skip harness, P/N 1599024, available from the National Vendors Parts Department.
Couple the left motor to the right motor. (See “Couple Motors” on page 85.)
Loading Trays With Product (continued)
1. REMOVE COLUMN
DIVIDERS
2. REMOVE
SPIRALS
7. INSTALL AN 11-COUNT LEFT HAND
SPIRAL IN THIS POSITION
INSTALL AN 11-COUNT RIGHT-HAND
SPIRAL IN THIS POSITION
8.
157P0040
4.
DISCONNECT THIS
MOTOR CONNECTOR
3.
LEAVE THIS MOTOR
CONNECTOR ALONE
5.
MOVE CONNECTOR
FROM THIS MOTOR
6.
TO THIS MOTOR