Merchant™ Operators’ Guide
Final Check-
1810006
39
January 2008
The spiral indexing procedures involve rotating spirals one position at a time until the product
vends properly.
1.
“Homing the Motors - Motor Status Detail” on page 65
2.
Remove the affected spiral.
3.
Is the coupler in the proper position?
NO
- Move the coupler to the position as shown in
“Installing a Spiral Coupler” on page 20
Go to step 4.
YES
- Move the coupler to the next clockwise position (if it's on a right-hand motor), or the next
counterclockwise position (if it's on a left-hand motor). Go to step 4.
4.
Replace the spiral.
5.
Perform a test vend (see the previous page).
6.
Did the product hang up?
NO
- You're finished. Continue to test vend the remaining selections until everything
works properly.
YES
- Go to step 7.
7.
Did you previously move the coupler to the next clockwise or counterclockwise position?
NO
- Move the coupler to the next clockwise position (if it's on a right-hand motor), or the next
counterclockwise position (if it's on a left-hand motor). Return to step 6.
YES
- Return to step 2 in the operational readiness check and try another procedure. Do not
move the coupler again.
The spiral indexing procedures involve rotating spirals one position at a time until the product
vends properly.
1.
Home all the motors (see
“Homing the Motors - Motor Status Detail” on page 65.)
2.
Remove the left hand spiral of the affected pair.
3.
Is the coupler in the proper position?
NO
- Move the coupler to the position as shown in
“Installing a Spiral Coupler” on page 20
Go to step 4.
YES
- Move the left coupler to the next counterclockwise position. Go to step 4.
4.
Replace the left hand spiral.
5.
Remove the right hand spiral, spiral coupler, and gear (if used) of the affected pair as a unit.
6.
Rotate this unit until the right hand spiral mirrors the position of the left hand spiral.
7.
Replace the right hand spiral, spiral coupler, and gear (if used).
8.
Perform a test vend (
see “Test Vend Selections” on page 38
9.
Did the product hang up?
NO
- You're finished. Continue to test vend the remaining selections until everything
works properly.
YES
- Go to step 10.
10.
Did you previously move the left hand coupler to the next counterclockwise position?
NO
- Remove the left hand spiral of the affected pair. Turn the left spiral coupler to the next
counterclockwise position. Return to step 4.
YES
- Return to step 2 in the operational readiness check and try another procedure. Do not
move the coupler again.
Spiral Indexing Procedure (One Spiral, One Motor)
Spiral Indexing Procedure (Two Spirals, One Or Two Motors)
Summary of Contents for Merchant 180
