Crane Merchandising Systems Merchant 180, Operator'S Manual

Page: 22 / 170

Initial Setup Merchant™ Operators’ Guide
January 2008 14 1810006
Operating Trays Outside the Merchandiser
The tray harnesses are long enough to remove the trays and set the middle and bottom trays
on the floor in front of the merchandiser and the top trays on the top of the merchandiser without
unplugging the tray harnesses.
Replacing a Motor With a Spiral Bearing
REMOVING A MOTOR
1. Disconnect the harness from the motor.
(See “Connecting and Disconnecting a Motor Harness” on page 15) .
2. Remove the spiral. (See “Removing and Installing Spirals” on page 16).
3. Remove the spiral coupler. (See “Removing a Spiral Coupler” on page 18).
4. Remove the motor. (See “Removing and Installing a Spiral Motor” on page 18).
INSTALLING A SPIRAL BEARING
1. Put the gear into position if required in this set-up as shown.
(See “Installing a Gear” on page 19).
2. Install the spiral coupler. (See “Installing a Spiral Coupler” on page 20).
A coupled spiral does not use a motor.
Removing and Installing
Column Dividers
1. Push the column divider toward the back
of the tray - .
2. Lift the column divider clear of the
tray - .
3. Install the column divider in the reverse
order of removal.
1
2
SPIRAL
BEARING
GEAR
SPIRAL
COUPLER
BACKWALL
OF TRAY
˜