SINGLE HEAD - USER MANUAL V1.2
42
7.9. Adjusting X belt tension
1.
Loosen the nut that secures the X-belts through
the hole with the provided 7-gauge wrench until the
block no longer locks the belts.
2.
Then tighten the nut.
7.10. Battery replacement
•
The battery type you need to replace is a CR2032.
»
Before installing the battery, also remove the screws
on the back cover. Be sure to disconnect the fan and
hood connection cables from the system board after
removing the back cover.
1.
Remove the depleted battery.
2.
Before inserting the new battery, turn on the printer.
3.
Insert the new battery into the system board.
4.
As a final step, turn off the printer again, then unplug
the power cord and reinstall the back cover as shown
in the first step.
7.11. Applying a new Kapton sheet
to your build plate
»
Build plate Kapton sheets get worn out in time or can
be damaged by the nozzle due to incorrect leveling or
removing the printed models. Reapplying a new Kapton
sheet if the old one has issues or damage is essential to
maximizing print quality. To reapply a new Kapton sheet,
take the build plate out of the unit and remove the old
sheet by stripping it off the flexible metal plate. Clean the
surface of the plate with acetone.
»
Remove the protective plastic backing sheet (keep this
aside for an upcoming step) from the new Kapton sheet
in order to expose the sticky side. Apply some window
cleaner to the plate and to the sticky side of the sheet
to help position the sheet on the build plate correctly.
Align the Kapton to the front side of the laser marked
grid. Once the positioning is correct, place the protective
sheet that was removed earlier on top the new Kapton
to prevent scratches and damage. Then squeeze out the
excess liquid from between the plate and the sheet with
a thin but solid object, like a used credit card.
»
Start from the center of the plate and move horizontally
and vertically. Once all the liquid has been squeezed
out and the sheet is applied properly, put the plate
somewhere to dry. Allow the sticky part to rest for a day
before using.
