SINGLE HEAD - USER MANUAL V1.2
11
3.3. Assembling the Craftbot Printer
•
Remove the X-rail clamps
»
To ensure your product was delivered safely, there are two clamps on the end
of the X-rail. Safely remove these by using the hex key provided by unscrewing
the 2 screws on each clamp.
»
Slide the clamps out by wiggling them from side to side.
•
Install the filament guide tube holder
»
Select the desired position for the filament guide holder. Choose its location
so that the filament spool holder fits beside it.
»
You can use any of the top plate screws to attach the filament tube holder
and the filament spool holder.
•
Install the filament guide tube
»
Position the filament guide tube as shown.
»
Insert one end of the filament guide tube into the filament guide tube holder
on top of the Craftbot appliance.
»
Push the other end into the hole on the top of the extruder.
•
Install the filament spool holder
»
Position the filament spool holder as shown.
»
Using a hex wrench, install the filament spool holder next to the filament
guide tube holder.
•
Mount the filament spool
»
Fit the filament spool onto the filament spool holder so that the lead end can
be fed straight into the filament guide tube holder.
•
Attach the power cord
»
Ensure that the power switch on the Craftbot is set to the OFF position.
»
Plug the AC power cord into the power socket on the back of the unit.
»
Plug the power cord into a wall socket.
