SINGLE HEAD - USER MANUAL V1.2
14
»
Press the NEXT button. The head is positioned above
the back right button and then above the back left
button screws.
»
Repeat the procedure for the remaining two knobs.
◊
If the measurement is correct, the Next button
appears. Pressing the button will proceed to the next
measuring point. Once all three measurement points
have been completed, the printer will re-check the
distances.
◊
If all is well, the measurement process is complete.
Mesh bed leveling
Creates a map of the build plate and compensates for
any surface inequalities while printing the first few layers.
For this calibration, no user intervention is required.
During the process, the printer measures the build plate
at 3 different temperatures: 60°C, 80°C, 100°C
(140 °F, 176 °F, 212 °F)
This process takes 15 minutes to complete.
FMS calibration
This calibration will measure the Filament Monitoring
System (FMS) sensor values and adjust them if necessary.
Make sure you select the correct type of filament on the
screen. The head heats up to the correct temperature.
After it has heated, load the filament to the extruder.
To extrude filament from the print head, use the down
arrow on the touch screen.
»
Press and hold the button to keep extracting filament
through the head.
•
Automatic filament feed can also be performed
by pressing the Load
button on the
bottom bar.
◊
By pressing the button once, the head automatically
extrudes some filament.
Filament loading is successful when the melted filament
flows out of nozzle evenly and vertically.
•
Caution! The freshly spilled melted filament is
hot. Avoid contact with spilled filaments or other
flammable materials in the nearby.
»
Press the Next button.
After successful FMS calibration you can print some cool
things.
