Part 3 - Configuration
51
-
Trip Direction
: Define in which direction the motion
has to occur in order for it to be considered an event.
Select In for movements from outside the selection
area in or Out for movements from inside the
selection area out.
-
OK
: Save the changes and exit the menu.
-
Cancel
: Exit the menu without saving the changes.
•
Actions
: Specify which actions to take when Trip Zone
is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
-
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, SNS, and/or Alert Window.
-
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
•
Trip Zone Ignoring Interval
: The system does
not produce event log entries or issues remote
notifications regarding Trip Zone events detected
during the specified time following the initial Trip Zone
event. Set a value between 1 sec and 5 secs or choose
Never.
Trip Zone Ignoring Time does not affect Trip Zone
recording.
•
Daytime Setup
: Specify when daytime starts and
ends. Adjust the time frame in 15-minute increments.
Times outside the specified range will be assumed as
nighttime by the system.
Tampering
•
No.
: Select which cameras to apply Tampering to.
•
Sensitivity
: Set to between 1 (Low) and 5 (High).
•
Activation Time
: Specify how long tampering
detection needs to last in order for it to be considered
an event. Tampering detections that do not last for the
specified duration of time will not be considered as
events.
•
Actions
: Specify which actions to take when
Tampering is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to
Event
or
Time & Event
mode, the selected
cameras will begin linked recording when an event
occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
-
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, SNS, and/or Alert Window.
-
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
•
Use Ignoring Time
: Select
Time Setup
to specify the
tampering detection ignore time. Tampering detection
will be disabled during the specified time frame.
