Part 3 - Configuration
50
In order to use the Callback feature, the NVR must be
registered on the remote program.
•
Motion Ignoring Time
: The system does not produce
event log entries or issues remote notifications
regarding motion detected during the specified time
following the initial motion detection. Set a value
between 1 sec and 5 secs or choose Never.
Motion Ignoring Time does not affect motion
detection recording.
•
Daytime Setup
: Specify when daytime starts and
ends. Adjust the time frame in 15-minute increments.
Times outside the specified range will be assumed as
nighttime by the system.
Trip Zone
•
No.
: Select which cameras to apply Trip Zone to.
•
Sensitivity
: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
•
Zone
: Define the motion detection block.
Use the remote control's arrow buttons to move the
block selection window up, down, left, and right. The
selection window consists of 8 blocks per row. Select/
deselect individual blocks using the
Camera
buttons.
You can use the mouse to drag the zone and then select,
clear, or reverse the selection.
From the zone selection screen, press the
button
on the remote control or right-click on the mouse to
open up the Zone Setup menu.
-
Select
: Confirm the block selection in the selection
window.
-
Clear
: Clear the block selection in the selection
window.
-
Reverse
: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
-
Select All
: Select all blocks.
-
Clear All
: Clear all block selections.
-
Reverse All
: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
