CORVUS TERRAIN DX4 PRO, User Manual

Page: 33 / 80

33 We reserve the right to modify the product and the design.
USER
MANUAL
BREAK-IN STAGE DAILY INSPECTION BEFORE DRIVING
It is IMPORTANT to respect the break-in stage which will ensure your
engine’s duration and correct functioning in the long term.
The following intervals should be respected:
• During the first 100 km. it is advised that you do not drive at maximum
power.
• From 0 to 200 km: Drive at between 50% and 75% of engine load
(throttle position), alternatively, without continued use
of 75% of engine load.
• From 200 to 300 km: Drive in the same way but occasionally, albeit not for
more than 5-10 seconds, at 100% of engine load.
• From 300 to 400 km: Drive at 75% to 100% of engine load, alternatively,
without maintaining peak engine load.
• From 400 km on, increase gradually the demand during between 60 to 80
km, until you reach peak performance.
Reckless acceleration can cause problems in the engine. Take care
that you use the skills and techniques needed to drive the vehicle.
These checks can actually be performed very quickly, it is a question
of habit. The user knows to what use the vehicle has been subjected
the last time it was used and where to intensify this control.
Respecting this set of controls implies greater security for the user
and, undoubtedly, better and more economical maintenance of your
vehicle.
Before driving, have the vehicle an a level surface and perform the following
checks:
Do you have enough fuel?
Check the current fuel level on your multifunction panel (1); try to fill the
tank before each use.
Is the engine oil level correct?
Use the cap/dipstick (2) to check that the level is adequate and, if
necessary, add oil.
MAX
MIN
2
1