51
13
Service
Replacing the H13 Filter
The VOC H13 Filter is a combined HEPA (High Efficiency Particulate Air) and VOC (Volatile Organic
Compound) filter. It is mounted on the side of the unit for easy access and replacement. The purpose
of the filter is to remove airborne particles and VOCs in the air being circulated within the incubator.
1.
The HEPA/VOC filter capsule has a limited
life in use of 3 months and therefore, it is
important to replace it on time in order to
maintain air cleanliness
2.
The filter is removed by a gentle rotation
of the filter element with one hand, and
pulling back the sliding part of the filter
holder
NOTE:
Mark the date change on the filter.
NOTE:
Do not use the filter without the correct
K-Systems fittings.
CAUTION:
Never use the filter or the filter holder as “handles” for moving the system.
Doing so may be hazardous as they may break off causing the system to fall to the
ground causing personal injury and damage to the system.
NOTE:
The flow direction on the side of the filter element (indicated by an arrow on the label) MUST
be the same as that shown on the side of the G185 incubator.
3.
Press one end of the new filter (remember
flow direction) into the stationary side of
the filter holder. It should align fully with
the base of the filter holder. Pull the end
fitting to the side as shown
4.
Then fit the other side of the filter into the
sliding part of the filter holder and slide it
into place. It may be necessary to twist the
filter element gently to get it to connect
fully
Summary of Contents for K-Systems G185 SensorTech
Page 55: ...55 11 Troubleshooting...
