CONVEY-ALL 2245-TL, Operator'S Manual

Page: 39 / 58

Operator’s Manual: 2200-TL Series Conveyor
Revised 06.2016 4-5
Fig 52 - Adjustment Bolt on Side of Hopper
Fig 53 - Hopper Flashing
Fig 54 - Hydraulic Drive
Fig 51 - Positive Pinch Drive Tension Bolts
4.2.2 Every 50 Hours or Weekly:
10. Check the conveyor belt tension.
Refer to Section 4.3.1
Note:
A properly tensioned belt will not slip
when in operation.
12. Check the condition of the rubber hopper
flashing. Be sure it still seals the hopper to
prevent leaking.
If any product comes out of the hopper around
the flashing, loosen flashing mounting screws
and adjust. Retighten anchor screws and try
running the conveyor again. Repeat until no grain
is lost.
If the flashing is stuck to the belt, manually peel
the flashing up and off the hopper. Replace it if
necessary.
13. Oil hydraulic drive coupler
11. Check conveyor belt alignment.
Refer to Section 4.3.2