CONVEY-ALL 2245-TL, Operator'S Manual

Page: 30 / 58

Operator’s Manual: 2200-TL Series Conveyor
3-12 Revised 06.2016
3.7 OPERATING ON SITE
When operating the conveyor, follow this procedure:
1. Clear the area of bystanders, especially small
children, before starting.
2. Review the Pre-Operation Checklist before
starting. Refer to Section 3.4
3. Review the Workplace Hazards schematic and
use extra care when inside the hazard area.
Should anyone enter this area, stop the machine
immediately.
4. Check that all guards are in place and working
as intended.
5. Back the truck/tender into position for loading or
unloading.
3.7.1 Starting Conveyor:
6. Turn throttle to its idle position.
7. Close the choke if the engine is cold or if the unit
has not been run for a while.
8. Turn the ignition key to start the engine.
Release the key when the engine starts.
9. Run for 2-3 minutes to allow the engine to warm.
10. Increase engine speed to full throttle.
11. Turn on the conveyor belt using the hydraulic
valve lever.
12. Start the flow of material and unload into hopper.
Fig 36 - Working Conveyor