Operator’s Manual: 2200-TL Series Conveyor
5-2
10.2015
Problem
- cont’d
Possible Cause
Possible Solution
Conveyor belt doesn’t turn or is slipping, cont’d
Hydraulic motor on drive roller may be damaged
Hydraulic motor may need to be replaced
Conveyor belt won’t align
Roller lagging may be worn
Replace roller or have it re-lagged
Conveyor Belt Fraying
Belt not aligned
Align and adjust tension
Product leakage
Product may be getting under the belt at the hopper,
traveling up inside the belt and leaking off delivery end
Replace hopper flashing
Low capacity
Conveyor belt not tight enough
Tighten conveyor belt
Conveyor belt not pinched enough
Inside drive box there is a drive roller and pinch roller.
Be sure the belt is snug between both rollers.
Conveyor angle exceeds 30 degrees
Reposition with a lower tube slope
Belt is slowing down
Problem with 2 stage pump
Check flow of the pumps. Replacement of entire pump
may be needed
No hydraulic flow
Hydraulic valve closed or plugged
Open hydraulic valve
Clean or replace hydraulic valve
Hydraulic pump may be damaged
Check hydraulic pump. Replace if necessary
Hydraulic pressure may be low, check gauge. It should
be in 2000lbs range
Check hydraulic pump. Replace if necessary
Drive wheel keeps sinking to the ground
Leak in hydraulic manifold or cylinder
Replace cartridge in check valve, or
replace seals in cylinder
Summary of Contents for 2245-TL
