CONVEY-ALL 2245-TL, Operator'S Manual

Page: 44 / 58

Operator’s Manual: 2200-TL Series Conveyor
4-10 Revised 06.2016
4.3.3 Conveyor Belt Replacement:
1. Rotate the conveyor belt until the Alligator Lacing
is positioned under the tube, inside the wind
guard, and is accessible.
2. Rotate the tension bolt in the drive box to its
loosest position.
3. Pull all the slack to the lacing area.
4. Remove the lacing pin and open the belt.
5. Attach one end of the replacement belt to the
end of the belt (to be removed) which is hanging
closest to the hopper.
IMPORTANT:
The open cup of the crescent belt pattern
must head towards the discharge,
when traveling through the tube.
See Figure 70
6. Pull the end of the old belt which is coming from
the direction of the discharge spout. The new
belt will follow and be threaded into place.
7. Disconnect the old belt.
8. Connect the ends of the new belt. Place the pin
in the Alligator Lacing.
9. Crimp the end of the pin.
10. Set the belt tension. Refer to Section 4.3.1
11. Set the belt alignment. Refer to Section 4.3.2.
Fig 68 - Tension Bolts
Fig 69 - Conveyor Belt Alligator Lacing
36-1800-0047
Fig 70 - Hopper Belt Path, Crescents Open to Discharge
Dischar
ge