CONVEY-ALL 2245-TL, Operator'S Manual

Page: 36 / 58

Operator’s Manual: 2200-TL Series Conveyor
4-2 Revised 06.2016
Storing Lubricants:
Your machine can operate at top efficiency only if
clean lubricants are used. Use clean containers to
handle all lubricants. Store them in an area protected
from dust, moisture and other contaminants.
4.1.1 Greasing:
Use the Service Record provided on page 4-15, to
keep a record of all scheduled maintenance.
1. Use a hand-held grease gun for all greasing.
2. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
3. All bearings are sealed and greasable. They
require minimal grease.
Recommended greasing is 1 small stroke every 2
weeks. Be careful not to over grease as this may
push the seal out.
4. Replace and repair broken fittings immediately.
5. If fittings will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
4.2 SERVICING INTERVALS
The conveyor belt alignment is preset to run true
under a condition of no load. It is important to check
alignment and make adjustments, if required, during
the initial few minutes of loaded operation.
Check bearings for wear daily.
The periods recommended below are based on
normal operating conditions. Severe or unusual
conditions may require more frequent lubrication and
oil changes.
Schedules may vary depending on options and
engine model contained in the present unit.
36-2200-0001
Fig 43 - CAT Diesel Engine