CONVEY-ALL 2245-TL, Operator'S Manual

Page: 47 / 58

Operator’s Manual: 2200-TL Series Conveyor
10.2015 4-13
4.3.7 Changing Hydraulic Oil and Filter:
1. Review the Operator's Manual for the engine.
2. Place all controls in neutral, stop engine and
remove ignition key before maintaining.
WARNING: Hot Liquid
Engine and hydraulics must to cool before
changing the oil. Hot oil can cause burns if
it contacts exposed skin.
3. Allow the engine to cool before changing the oil.
Note:
It is best to change oil
while the engine is warm
to keep contaminants in suspension.
4. Place a large pan, pail or tank under the drain
plug.
5. Remove the drain plug and allow the oil to drain
for 10 minutes.
6. Install and tighten the drain plug.
7. Dispose of the used oil in an approved container
and manner.
8. Place a pan under the filter to catch any spilled
oil.
9. Remove hydraulic oil filter.
10. Apply a light coat of oil to the O-ring and install
the replacement filter. Snug up by hand and then
tighten another 1/2 turn.
11. Fill the reservoir with specified oil.
12. Run the engine for 1-2 minutes and check for oil
leaks.
13. If leaks are found around the drain plug or filter,
tighten slightly. Repeat Step 10.
14. Check oil level. Top up as required.
Fig 75 - Hydraulic Oil Reservoir
Fig 76 - Hydraulic Oil Filter