CONVAI D U SER’S G U I DE
WARNING:
Always remove the user from the chair prior to removal of the seating mod-
ule from the mobility base. Removal of the seating module is only intended for facilitating
lifting and transportation of the chair. The user should never be placed in the seating
module if it is not properly attached to the mobility base. The mobility base should never
be used without the seating module assembly properly installed.
WARNING:
The seating module shall NEVER be used as a car seat.
Removing seating module from Mobility Base
1. Engage wheel locks.
2. Remove user from the chair.
3 Adjust seat back to upright position.
4. Adjust tilt to neutral position so that the seat pan is parallel to the floor.
5. Hold seat base lock bar
Fig. 32
and push safety lock release lever
Fig. 33
6. Lift seat module release bar.
7. Once seat base lock bar is released, push on the upper back to release seating module from
docking platform on the mobility base.
Fig. 34
8. Lift seating module from the base.
Safety lock
Removal from base
Safety Lock
Seat module release handle
Removing Seating Module from Mobility Base
Fig. 32
Fig. 33
Fig. 34
WARNING:
During transit, chair must be forward facing with the seating module in the for-
ward facing position on the mobility base with the storage basket removed.
WARNING:
Armrest combined with a contoured seat cushion will interfere with chair frame
and tilt, therefore armrest must be adjusted to the lowest width; 12”.
This can be achieved by removing the additional foam inserts found in the contoured cushion
and adjusting armrest inwards.
!
!
!
!
12
Summary of Contents for Trekker
Page 47: ...NOTES 43 ...
