Installation
10
Power ON the scanner
Turn ON scanner power
Turn on the main power switch at the back of the scanner
Connect Cables
Connect the USB interface cable to the scanner
Initial installation and activation of the scanner is easiest using the USB connection.
This applies also for Gigabit enabled models.
1. The interface-connection-panel is found at the back of the scanner
– on its left side when facing
the back.
2. Connect the B-connector end (square shaped) end to a USB port on the scanner.
NOTE: For Gigabit enabled scanner models:
The installation wizard will instruct you on
installation and activation of the gigabit interface
later
in the installation process. For now
– only connect
the USB.
Regulatory Notice:
Your scanner product has been tested to comply with the EMC Standards EN55022 and
FCC, Part 15. To maintain compliance, only use the interface cables supplied with the scanner.
IMPORTANT
:
Do not yet connect the other end of the USB to the PC.
10
9
