Board Setup
COM-2(PCI), COM-4(PCI), COM-8(PCI)
32
For Other OS Systems
For all the other operation systems, in addition of the Windows OS,
we use MS-DOS/Windows 3.1 as an example to show how to use
the board under the OS.
For all the other operation systems, refer the MS-DOS programs of
the attached FD as an example.
For a PCI bus board, the system will automatically assign a usable
resource/resources to the board. Refer the following procedure to
copy the attached programs and to confirm the assigned
resource/resources.
Hardware Installation Steps
(1) Set the board ID.
(2) Be sure that the personal computer is off; then plug the board
into a PCI bus slot in the personal computer.
(3) Turn the personal computer ON to start up MS-DOS.
(4) Run the resource checking program (COMPCI.EXE) from the
DOS directory of the supplied floppy disk.
(5) Check the I/O address and interrupt level displayed on the
screen. If the I/O address and interrupt level are displayed
correctly, the board can be used on MS-DOS and
Windows 3.1.
Obtaining resource information
You can obtain the PC resource information assigned to the board
by accessing the PCI BIOS. For specific details, refer to the
sample programs in the DOS directory of the supplied FD.
Summary of Contents for COM-2(PCI)
