Board Setup
COM-2(PCI), COM-4(PCI), COM-8(PCI)
26
(7) In the [Driver Files Search Results] dialog box, check that
"COM2K_PI.INF" in the [Windows found a driver for this
device] has been listed, then select [Next>].
However, do not check it in a check box.
(8) In the next dialog box, check the "Completing the found New
Hardware Wizard.", and "CONTEC Co.,Ltd.COM-x(PCI)"
message, then select [Finish]. After completed the board
installation, be sure to check the assigned resources. The
"Checking resources" part of this section explains you how to
check the OS assigned resources of this board. (When board
setup has been completed, be sure to check the assigned
resources.)
(9) Run Config.exe from \CONTEC folder to which file were
copied. Enter the COM port No. in Config.exe.
(10) After restarting system, the board enable the board to te used
as standard COM port.
Notes!
- The board cannot be properly installed unless the resources
(I/O addresses and interrupt level) for the board can be
allocated. Before attempting to install the second board, first
determine what PC resources are free.
- The resources used for the board do not depend on the location
of the PCI bus slot or the board itself. If you remove the board
that have already been installed and then remount one of them
on the computer, it is unknown which one of the sets of
resources previously assigned to the two boards is assigned to
the remounted board. In this case, re-check the resource
settings.
Summary of Contents for COM-2(PCI)
