Board Setup
COM-2(PCI), COM-4(PCI), COM-8(PCI)
20
For Windows 95 version 4.00.950 or 4.00.950a systems:
(1) Set the board ID.
(2) Be sure the power of the personal computer is turned off; then
plug the board into a PCI bus slot in the system.
(3) Turn the personal computer ON to start up Windows 95.
(4) Windows 95 will come up with the [New Hardware] detection
dialog box. Select [CONTEC Co.,Ltd.-COM-x(PCI): Select
which driver you want to install for your new hardware.] and
then [Driver from disk provided by hardware manufacturer].
(5) In the [Install From Disk] dialog box, insert the attached FD
into the disk drive, enter the drive name and directory name in
the [Copy Distributed File From] field, then click [OK].
This completes installation of the board.
(6) Follow the instructions on the screen to complete installation
of the board. After completed the board installation, you are
supposed to confirm the registered board information from
Windows 95 registers. The "Checking resources" part of this
section explains you how to do it.
(7) After restarting system, run Config.exe from\CONTEC folder
to which file was copied.
Register the COM port No. in Config.exe.
(8) After restarting system, you can use registered COM port as
standard COM port.
Summary of Contents for COM-2(PCI)
