Contec COM-2(PCI), User Manual

Page: 17 / 80

Component Locations and Setting
COM-2(PCI), COM-4(PCI), COM-8(PCI)
10
Setting the Board ID
If two or more boards of the same type are installed in the same PC,
a board ID is assigned to identify each board. Set a different value
for each board.
The board IDs can be set in the range 0 to F enabling a maximum of
16 boards to be identified.
However, the range for COM-4(PCI) is 0 to 7, giving a maximum
of 8 boards.
Setting Procedure
The board IDs are set on a rotary switch on the board. Rotate
SW1 to the desired setting. However, do not set board IDs 8 or 9
on the COM-4(PCI) as these ID numbers are not used. The rotary
switch setting shown in the figure sets board ID 0.
Figure 2.4. Board ID Settings (SW1)