Consilium SELUX ST, Installation And Service Manual

Page: 14 / 180

Selux ST Installation and service manual
2 Rev. E
SAFETY PRECAUTIONS
Purpose
The safety precautions described in this paragraph are applicable to Selux St.
Depending upon the material to be highlighted, the following attention letter
headings are used in the technical manual content.
WARNING
THIS IS OPERATING OR MAINTENANCE PROCEDURE,
PRACTICE, CONDITION AND STATEMENT WHICH. IF NOT
STRICTLY FOLLOWED, COULD RESULT IN INJURY TO OR
DEATH OF PERSONNEL
WARNING
THIS IS OPERATING OR MAINTENANCE PROCEDURE,
PRACTICE, CONDITION AND STATEMENT WHICH. IF NOT
STRICTLY OBSERVED, COULD RESULT IN DAMAGE TO,
OR DESTRUCTION OF, UNIT OR LOSS OF EMISSION
EFFECTIVENESS.
NOTE
An essential operating or maintenance procedure, condition or
statement which must be highlighted
Whenever a precaution, relating specifically to a part of the technical manual is
needed, the information is given in the relevant part of the manual. Warnings
and Cautions precede applicable text.
Safety Operations
During normal operation (front cover closed), the unit can be quickly
disconnected from the main power line, setting to OFF the relevant circuit
breaker located on the electric switchboard.
During maintenance (front cover opened) it is possible to turn-on the unit by
setting to SERVICE MODE the SW2 switch, mounted on the RTM Supply Assy.
This switch is connected in parallel with the relay, controlled by the POWER ON
command, and during normal operation must be set to NORMAL. During
maintenance, in order to prevent RTM occasional turning-on it is better to
disconnect and insulate, momentarily, PWON terminal from the relevant
terminal board.
NOTE
Main power line is always present on terminal board and on
fuses