Consilium SELUX ST, Installation And Service Manual

Page: 85 / 180

RADAR CONFIGURATION
3.12 Rev. E
3.8 TXRX Settings
Press the
G
button of fig. 3.1.2 and the window below will appear. The above mentioned
buttons can be maximum two if only the Alpha PCB. is installed to interface the
transceivers and can be up to four if a Alpha Expansion PCB is present, on which can be
connected the 3
rd
and the 4
th
TXRXs. In the "TXRX n SETUP MENU" (where n is the
number of the TXRX chosen) is possible to adjust the TXRX parameters such as video ,
heading line, azimuth type, etc.
Figure 3.8.1 TXRX Settings Menu
NOTE
In case of connection with a MOSFET transceiver with an "RTM Control
P.C.B." on board instead of an "RTM Control B P.C.B." (TXRX software
version lower than 54), the buttons in position 12-15-16-17-19 will not be
activated. In case of connection with a non Consilium Selesmar
transceiver or with an old transceiver type (non MOSFET), all the buttons
above and the button in position 5 will be not activated.
The E button selects the protocol to use ( NMEA or Consilium Selesmar) and depends
from the transceiver connected. All SRT and SRT derived transceivers work with NMEA
protocol.
The two communication modes are working ad different baud rates (2400 bps Consilium
Selesmar, 4800 bps NMEA). Beside, checking the TXRX documentation the different
types can be understood directly from the Debug Display window (see Debug Chapter),
selecting the TXRX communication messages.
A
B
C
D
E
F