Consilium SELUX ST, Installation And Service Manual

Page: 80 / 180

RADAR CONFIGURATION
3.7 Rev. E
3.5 Conning and EPFS Pos. Configuration Menu
By pressing the “Conning and EPFS Position” button the following window will appear:
Figure 3.5.1 Conning and EPFS Position
Conning Position:
look to the help line to correctly use the 3 Mouse Operating Push
Buttons in order to decrease, increase the X or Y value or input a new X or Y value in
meters. A picture of the ship profile and a text on line will be drawn in order to help the
operator to insert the correct values. (is the position of the EPFS referred to the graphical
shape as indicated in the figure). This value is used to calculate the exact geographical
coordinate of the antenna position. Length and width are not used when the AIS is
connected, instead they are extracted from the VDO static message). The CCRP will be
located on the conning position.
EPFS Ant. Position: look to the help line to correctly use the 3 Mouse Operating Push
Buttons in order to decrease, increase the X or Y value or input a new X or Y value in
meters. A picture of the ship profile and a text on line will be drawn in order to help the
operator to insert the correct values. (is the position of the EPFS referred to the graphical
shape as indicated in the figure. This value is used to calculate the exact geographical
coordinate of the GPS antenna position.
EPFS Datum Check:
Accept the DTM sentence when the checkbox is signed. The datum
is used to compensate local geographic coordinates with an offset referenced to WGS-84