Consilium SELUX ST, Installation And Service Manual

Page: 25 / 180

INSTALLATION AND SETTING
1.8 Rev. E
Feature Characteristics
Speed Log Mechanical input:
. PRR: 100 pulses/NM, 200
pulses/NM, 400 pulses/NM
. Input type: diode isolated, pull-up
. pulse width: 1 ms (min)
. Load: ≥ 2.7 KΩ
. Threshold: +10 V (typ)
Speed For
Electronic input
(switch):
. PRR: 120 pulses/m, 20000
pulses/NM
. Load: ≥ 1 KΩ
. Pulse width: 0.1 µs (min)
. Voltage: TTL to 15V (typ)
Speed Serial
Electronic input
(serial):
. Input type: RS422 standard NMEA or
RS 232
. Load: ≥ 3 KΩ, terminated 120 Ω
System Failure
(FAIL)
TB1 (pin 5-6)
Relay output NC
Closed when the system is in failure or
switched off
- Max 125 V 30 W load
Danger Target
(DGT)
TB1 (pin 3-4)
Relay output NC/NO
configurable
Active when a Radar Target or AIS is
dangerous
- - Max 125 V 30 W load
Dead Man Alarm
Reset (DNA)
TB1 (pin 1-2)
Relay output NC/NO
configurable
Active when an action is made on the
control panel
- Max 125 V 30 W load
Video and Combined data without
ALPHA Expansion or CH3 and CH4
with this card
. Voltage value: 0,8 to 1,5 Vpp adjustable
. Load: ≥ 1 KΩ, terminated 75 Ω
Video and data with Alpha Expansion CH1 and CH2: (Optional)
Video:
Polarity: . Positive or negative
Amplitude: . 1 to 4 Vpp adjustable
Load: . Load: ≥ 1 KΩ, terminated 75 Ω
Bandwidth: . 24 MHz (-3 dB)
Trigger: Polarity: . Positive or negative
Amplitude: . TTL to 40 V (peak)
Load: . Load: ≥ 1 KΩ, terminated 75 Ω
PRF: . 300 to 4000 Hz
Pulse width: . 50 ns (min.)
Serial Interface: Signal Standard:
. RS232 or RS422
. Load: ≥ 3 KΩ, terminated 120 Ω
Antenna Rotation Rotation rate: . 15 to 60 RPM
Data Device type:
- Bearing
. Voltage value: 4 to 50 V
. 128 or 132 pulses per antenna
revolution
. Load: ≥ 2 KΩ
- Encoder
. Voltage value: 4 to 50 V
. 1024 or 4096 pulses per antenna
revolution
. Load: ≥ 2 KΩ
Heading line Voltage value: . 4 to 50 V
Load: . Load: ≥ 2 KΩ
Pulse width: . ≥ 0,1 mS and < 45°
Polarity: . Positive or negative or bipolar