Consilium SELUX ST, Installation And Service Manual

Page: 96 / 180

RADAR CONFIGURATION
3.23 Rev. E
3.11.2 IP Address (Fig 3.11.1 -B)
The IP Addresses next to the “This Console” label are about the working console. The
“PROC A IP” column is about the IP address of Processor A of Antares p.c.b.
The Proc A IP of This Console can beset by clicking in the IP address field.
The Proc B IP will set automatically consequently.
Figure 3.11.1-B
The following functions can be used only if This Console is connected via LAN with other
Selux ST consoles:
Scan Other Nets
The Selux-ST console searches trough 10.x.x.x, 192.168.0.x, 172.1.x.x and 212.4.5.x
subnetworks for other Selux-ST units.
All the consoles available will be presented in the table.
Set All Sequentially
After a scan identification, the IP of the listed consoles in the table can be set in an
incremental way starting from own console IP number.
The assigned IP will be incre2 for every console found and a dialog window will
be shown on each one to accept the IP setting request.
Send Configuration
This function can be used to share the configuration of This Console with the other ones.
Please note that Transceiver, Antenna and Video/Trigger settings may be needed to be
re-configured on each console.